Machine Concepts’ Parts Retrieval Systems are a reliable, cost-effective way of removing parts and scrap from the die.
Machine Concepts’ Parts Retrieval Systems are designed to pick up and remove up to 4 parts (2 inner and 2 outer) from the bottom die and catch the scrap as it is being released from the upper die. After the part is stamped and the die is opening, a shuttle plate will enter the die cavity to pick up the parts and scrap, then begin retracting. As the shuttle plate is retracting, a fixed plate will scrape the scrap off the top of the shuttle plate on a customer-supplied conveyor. The shuttle plate will continue to retract and drop the part(s) on a customer-supplied conveyor or tote. After the shuttle plate has evacuated the die cavity, the press will begin to stamp another part. Additional shuttle plates can be purchased for a different number of parts, sizes and locations.
Max. Parts Weight | 2 lbs. |
---|---|
Max. Scrap Weight | 2 lbs. |
Min. Thickness | Application Dependent |
Max. Thickness | Application Dependent |
Max. Speed of Shuttle | 30 SPM (subject to press travel and speed) |
Largest Part Diameter | Application Dependent |
Smallest Part Diameter | Application Dependent |
A foot operated hydraulic kart with locating pins and Destaco clamps to lock onto the retrieval system and clamp it to the kart. Once clamped, the operator can raise the table and roll the system out of the way to access the dies.
Parts Retrieval System Mounted to Press
Parts Retrieval System Removal Kart
Parts Retrieval System Mounted to Press